Model 1445C • 1500 Watts Model 945C • 1000 Watts Model 645C • 825 Watts Model 632C • 585 Watts
The contractor shall supply and install CeramiCircuit™ infrared cove mounted heating panels, manufactured by Radiant Electric Heat, of the wattage and voltage specified on the plan. The heater shall be designed to provide maximum radiant heating energy output.
Heater elements are to be constructed of ceramic coated 18 gauge steel plates with an energizing circuit on the internal face of the heating element.
Heater body shall be a 20 gauge galvanized steel construct with the ventilation slots at perimeter and 20 gauge steel bezel with power coating.
Heater shall have a junction box of approximately 6-3/4" on the back side of the heater body. There shall be three 7/8" standard knockouts in the junction box to allow entry of power feed. Actual power connections to the element and heater grounding connection shall be at the left end of the heater. Multiple units shall be wired in parallel with direct connections to each unit entering junction box from wall.
Heater elements shall have a wattage density of a minimum of 2.3 watts/square inch of emissive surface area.
Contractor shall install manufacturer's supplied powder coated mounting brackets (2) as specified on the plan, and finish with supplied panel end trim pieces (2).
Heaters shall be rated at 585 watts (Model 632C), 825 watts (Model 645C), 1000 watts (Model 945C), or 1500 watts (Model 1445C) in appropriate voltages of 120 volts, 208 volts, 240 volts, or 277 volts.
Heaters shall be listed and approved by Underwriters Laboratories
Each CeramiCircuit installation is engineered to meet the particular heating characteristics of the building and to ensure comfort, economy, and performance. We will be pleased to guide you in proper design and placement. Be it a cold room or an entire structure, Radiant Electric Heat is the solution.